Cleaning The Brewing Unit - Siemens TE506 Séries Mode D'emploi

In addition to this, clean the milk system
thoroughly at regular intervals (by hand or
in the dishwasher).
Dismantling the milk system for cleaning:
1. Pull the milk frother (6) forward out of
the appliance.
2. Dismantle the milk frother into its indi­
vidual parts (6a to 6d) (see figure C at
the start of the operating instructions).
3. Clean the individual parts with a deter­
gent solution and a soft brush. If neces­
sary, soak in a warm detergent solution.
4. Rinse all parts with clear water and dry
them.
5. Reassemble all the parts and replace
fully in the appliance.
¡
Risk of scalding!
Use this appliance only after the milk frother
(6) has been fully assembled and installed.

Cleaning the brewing unit

Clean the brewing unit regularly!
To pre­clean the brewing unit automatically:
e
1. Select by turning the rotary knob (15).
2. Place an empty glass under outlet (6a).
3. Press the start button (10).
The appliance rinses.
In addition to the automatic cleaning pro­
gramme, the brewing unit (5a) should be
removed regularly for cleaning. (See figure
E at the start of the operating instructions.)
1. Switch the appliance off at the power
on/off switch O / I (9). No buttons are lit.
2. Open the door (5b) to the brewing unit.
3. Slide the red lock (5e) on the brewing
unit completely to the left.
4. Press the red button (5d), grasp the
brewing unit by the recessed grips and
remove carefully.
5. Rinse the brewing unit (5a) thoroughly
under running water.
en de
31