Simple Troubleshooting - Siemens TE506 Séries Mode D'emploi

de en

Simple troubleshooting

Problem
Display shows
Refill beans!
although
the bean container (1) is full,
or the grinding unit does not
grind the beans.
No hot water dispensed.
Too little or no milk froth
or
the milk frother (6) does not
draw the milk in.
Coffee dispensing slows to
a trickle or stops completely.
Coffee has no "crema".
If you are unable to solve the problem, please call the hotline.
You will find the telephone numbers at the back of these instructions.
36
Cause
Beans are not falling into
the grinding unit
(beans too oily).
The milk frother (6) is soiled. Clean the milk frother (6),
The milk frother (6) is soiled. Clean the milk frother (6),
Milk unsuitable for frothing.
The milk frother (6) is not
correctly assembled.
Build­up of limescale in the
appliance.
Coffee is ground too finely.
Pre­ground coffee is too
fine.
Build­up of limescale in the
appliance.
Unsuitable type of coffee.
The beans are no longer
fresh.
The grinding setting is not
suitable for the beans.
Solution
Gently tap the bean con­
tainer (1).
Change the type of coffee if
necessary.
When the bean container
(1) is empty, wipe it with a
dry cloth.
see "Maintenance and daily
cleaning".
see "Maintenance and daily
cleaning".
Use low­fat milk (1.5 % fat).
Wet the milk frother parts
and press together firmly.
Descale the appliance
using two descaling tablets,
if necessary repeat the
procedure.
Adjust the grinding unit to a
coarser setting. Use coarser
pre­ground coffee.
Descale the appliance.
Use a type of coffee with a
higher proportion of robusta
beans.
Use fresh beans.
Adjust grinding setting to
fine.