Siemens TE506 Séries Mode D'emploi page 29

Switching on the appliance
1. Remove the protective film.
2. Place the fully automatic espresso
machine on a flat, water­resistant sur­
face that can take its weight. Make
sure that the machine's ventilation slots
remain unobstructured.
Important: Only use the appliance in
frost­free rooms. If the appliance has been
transported or stored at temperatures below
0 °C, wait at least 3 hours before operation.
3. Pull the power cord out of the storage
compartment (21) and plug in. Adjust
the length of the cable by pushing it
back in or pulling it out. The easiest way
to do this is to place the appliance so
that its back is flush with the edge of the
counter and either pull the cable down-
ward or push it upward.
4. Install the milk frother. Operate the ma­
chine only after the milk frother (6) has
been fully assembled and installed.
5. Lift the lid of the water tank (18).
6. Remove and rinse the water tank (17)
and fill it with fresh cold water.
Do not fill above the max mark.
7. Replace the water tank (17) and push it
firmly downward into place.
8. Close the lid of the water tank (18)
again.
9. Fill the bean container (1) with coffee
beans (for preparation using ground
coffee, see "Preparation using ground
coffee" on page 28).
10. Press the power switch O / I (9). The
display (16) shows the menu for setting
the display language.
11. Select the required display language
with the upper rotary knob (15).
The following languages are available:
Deutsch
English
Français
Italiano
12. Place a receptacle under outlet (6a).
13. Press the start button (10).
The language you selected is saved.
The appliance heats up and rinses. Some
water will run out of the coffee outlet.
When the drink selection menu is shown in
the display, the appliance is ready for use.
Switching off the appliance
If the appliance has not been used for
an hour, it rinses automatically and then
switches off (time span can be programmed,
see "Menu settings"
Exception: The appliance switches off with­
out rinsing if only hot water or steam were
dispensed.
To switch the appliance off manually before
e
this, press the off /
appliance rinses and switches off.
N.B.: If the appliance is being used for the
first time, a service program has been run,
or the appliance has not been operated
for a long period, the first beverage will
not have the full aroma and should not be
consumed.
When using the espresso machine for the
first time, you will achieve a suitably thick
and stable "crema" only after the first few
cups have been dispensed.
After extended use, water droplets may
form on the ventilation slots. This is normal.
Shut off
on page 27).
j
button (13). The
en de
25