2-14. Auto Registration Offsets; Important - Sony KP-57WV600 Manuel D'utilisation

2-14. AUTO REGISTRATION OFFSETS

IMPORTANT

This adjustment must be performed after registration adjustment
or after readjustment for any reason!
Once registration in all modes is satisfactory:
1. Darken the room environment near the set.
2. Enter service mode and individually write data
("MUTING" + "ENTER") for:
Full
Zoom
Wide Zoom
1080i
Important:
You must complete step 2 even if registration looks OK in these
modes and there were not any adjustments made.
Note: If 1080i source is not available, 1080i data can be displayed by
entering Twin Mode.
3. Select input of RF (with a signal) or Video1 - Video4 (with a signal),
and enter Full Mode.
WARNING: DO NOT USE 1080i SIGNAL!
4. From service mode, select the PJE group.
5. To automatically store the offset values, press the "FLASH FOCUS"
button on the front panel of the set.
(The offset value is now stored)
If FLASH FOCUS successfully calibrates, it displays
"CALIBRATION OK."
If FLASH FOCUS does not successfully calibrate,
an error message is displayed.(Refer to section 2-15)
6. Exit the service mode.
7. If the calibration was successful, press the "FLASH FOCUS" button
out of service mode.
8. ConÞ rm registration is OK in all modes.
— 53 —
KP-57WV600/57WV700/
65WV600/65WV700