Adjusting The Convergence Manually - Sony KP-57WV600 Manuel D'utilisation

Adjusting the Convergence Manually

z
For details on using the
Setup Menu, see page 83.
The Convergence feature gives you more control over the picture's
convergence than the Flash Focus feature, allowing you to fine-tune the
convergence.
✍
Before using the manual Convergence, you must first perform Flash Focus
(as described on page 44).
1
Press to display the Menu.
MENU
2
Move the joystick
.
3
Move the joystick to highlight
A pattern of white crosses appears, with a yellow
of the crosses. Aligned crosses (which do not need adjustment)
look white and have little or no red or blue showing. Crosses that
are not aligned show red or blue shades beyond their edges.
You can scroll up and down through the 9 x 7 field of crosses to
manually converge all portions of the screen.
4
Using the joystick, move the
to adjust. Press
5
If the cross that you selected has red edges, move the joystick
until the red image is replaced with a white cross. Once you have
finished this (or the cross does not have red edges), press
changes to blue.
6
If the cross you selected has blue edges, move the joystick until
the blue image is replaced with a white cross. Once you have
finished this, press
7
Repeat steps 4 to 6 to adjust other crosses. When finished, press
to exit the Setup Menu.
MENU
B or b to highlight the Setup icon and press
Convergence
to surround a cross that you want
. The changes to red.
. The changes to yellow again.
and press .
around one
. The
45