G Board; B Max Voltage Conþ Rmation; B Ovp Conþ Rmation - Sony KP-57WV600 Manuel D'utilisation

G BOARD

3-3. +B MAX VOLTAGE CONFIRMATION
The following adjustments should always be performed when replacing
IC6503 R6518.
1. Supply 130VAC to variable autotransformer.
2. Receive dot signal pattern and set the PICTURE and BRIGHTNESS
settings to their minimum.
3. ConÞ rm the voltage of TP +B 135V is less than 137.0Vdc.
4. If step 3 is not satisÞ ed, replace IC6503 and repeat steps 1-3.
3-4. +B OVP CONFIRMATION
1. Add to low voltage power supply between to TP. 6502 and ground.
2. Supply 120VAC to variable autotransformer.
3. Power on the Set and receive dot signal pattern.
4. Set the PICTURE and BRIGHTNESS settings.
5. Check the OVP is activated.
Operate :less than 2.50V
— 57 —
KP-57WV600/57WV700/
65WV600/65WV700