Table des Matières
Publicité
3.12 BEFORE STARTING WORK
Before starting the seeding operation grease all parts indicated by
transfer nr. 15 ('GRASE') at page 43 of this leaflet.
IMPORTANT
Before starting, lift the supporting base elements.
Before parking the seeder, lower the supporting feet by carrying
out the operation in the reverse order.
3.13 OPERATION START
WARNING!: Remove the safety pins and lift the planting unit so
that it completely clears the ground before handling the side
frames (Fig. 65).
In the presence of dampness, make the fan idle for a few minutes
to dry the pipes.
IMPORTANT
For a successful seeding work it is useful to seed on a small
stretch and check that the seeds are regularly distributed in the
ground.
3.14 DURING WORK
Bear in mind that a variation in tractor speed does not lead to a
corresponding variation in seed sown per hectare.
Always respect the following rules for successful sowing:
- Keep the hydraulic lifting device in the lowest position.
- During the seeding operation, always maintain the number
of rotations for the requested power take-off.
- Check at times that the operating parts are not covered with
vegetable residual matter or clogged by earth
cod. G19503360
USE AND MAINTENANCE
- Check that the distributor is clean, and prevent any external
matter (no seed) accidentally fallen into the hopper from
hampering the smooth seeding operation.
- Check in any case that the grain tubes are not clogged
- Maintain a seeding speed compatible with type and cultivation
of the soil
- Periodically check the results of seeding.
- The form dimensions and material of the drive shaft elastic
pins have been chosen for safety. The use of pins not original
or more resistant, could cause serious damage to the seeding
machine.
- Avoid curves with the machine grounded, neither work in
reverse.
Always lift it when changing direction or reversing.
- Start the power take-off progressively; sudden movements
are harmful to the belt.
- Maintain a seeding speed compatible with type and cultivation
of the soil in order to avoid breakages or damage.
- Lower the seed drill when the tractor is in forward gear, to
avoid clogging or damage to the planter shoes; for the same
reason the tractor should not reverse when the seed drill is
on the ground.
- Make sure that no foreign material (rope, sack paper) enters
the storage tank when seed is being loaded.
The seeder can transport treated chemical substances
together with the seed. Do not allow children, people, pets to
come near the seeding machine. Keep away from the seed
storage tank and refrain from attempting to open it when the
seeder is working or about to begin working.
g
ENGLISH
CAUTION
DANGER
67
Publicité
Table des Matières
