Further Settings; Displays On The Control Module; Setting-Up Procedure - GILGEN KABA doorboy DBL-S Instructions De Montage Et D'exploitation

3.2.2

Further settings

DIL 4 OFF
ON
DIL 5
DIL 6 OFF
ON
LED 31: Open/Close
LED 32: Stop
LED 33: Reverse
LED 34: ERROR
3.2.3

Displays on the control module

4 LED's are installed on the control module. They are lit in order to display the following situations:
LED 31 green
LED 32 green
LED 33 geen
LED 34 red
3.3

Setting-up procedure

The setting-up procedure is initiated when the mains supply is switched on for the first time or upon actuating the
RESET key Fig.13, during at least 2 seconds from any possible door position.
- Drive unit function FULLY AUTOMATIC (VA):
The setting-up procedure is started without receiving an impulse.
- All the other drive unit functions:
In order to initiate the setting-up procedure, a closing or step-by-step impulse must be given.
- The first movement carried out by the door is a slow closing motion.
- As soon as the door is completely closed, give an opening impulse. The door opens at slow speed up to the OPEN
position. At the beginning of the opening motion the door mass is measured by means of a short acceleration.
- Now the door travel distance is memorized.
0552-999-04a_08.2001.p65
Sliding and overhead door with stroke > approx. 1'100 mm (z = 10)
Overhead door with stroke < approx. 1'100 mm (z = 10)
For sliding doors: set to ON
Setting the illumination time on potentiometer R49
Setting the hold-open time for fully automatic on potentiometer R49
DBL Soft
VX.YY.ZZ
An opening or closing command is pending
Is lit: a stopping command is pending
A reversing command is pending
ERROR = a system error has occurred. In order to obtain a detailed error
analysis, the BEDIS can be connected to plug X7.
The door must not be impeded during
the setting-up procedure.
0552-999/04a
Attention:
DBL-S
13-19
Tab. 4
DIL switch
Potentiometer R49
Setting-up key (RESET)
Fig. 13