Power Supply System Strozu - GILGEN KABA doorboy DBL-S Instructions De Montage Et D'exploitation

- Plug the screw nipple (21) onto the cable end and loop the steel cable (19). Tighten the screw nipple (21) after
the actuation lever (18) has been folded back.
- Stretch the steel cable (19) by unscrewing the drilled screw (24). Tighten the securing nut (29).
Fig. 10
Checking:
View B
2.3.6

Power supply system STROZU

- Mount the power supply system within the drive unit, according to separate instructions, and connect it to the
control unit.
- Fasten the included branch box on the door, in close vicinity to the door driver.
- Lay out the cable of the power supply system to the branch box, via the drawbar.
- Plug the rubber sealing bungs of the branch box onto the cable and connect the cable to the luster terminal.
- Lead the cables of the safety elements to the branch box and connect them (making a bridge connection for any
missing element).
- Place the cable and the luster terminals with the rubber bungs into the branch box and screw down the cover.
- Several elements can be connected to the unassigned terminals. Connect them with the STROZU by means of
jumpers. Fig. 11, Fig. 12
Safety element Reversing
yw gn
0552-999-04a_08.2001.p65
When the actuation lever (18) is folded out, the sliding carriage (17) must be disengaged so
that the door can be freely moved back and forth.
bn wt
STROZU
Safety element Stop
0552-999/04a
DBL-S
11-19
26
24
29
18
19
28
21
yw gn bn wt
STROZU
Fig. 10