Mount The Drive Unit - GILGEN KABA doorboy DBL-S Instructions De Montage Et D'exploitation

2.3.4

Mount the drive unit

- Mount the suspension angle (15) loosely to the ceiling.
- Insert the sliding nuts in front into the aluminium profile (16), spacing them in accordance with the suspension
angles (15).
- Lift up the aluminium guideway profile (16) in front and screw it down to the suspension angle (15), next to mounting
hole (12). Fig. 7
10
* Additional suspension if measure B exceeds 3'500 mm
- Lift the drive head (10) and fasten it loosely to the rear suspension angles (15), next to mounting hole (13).
- Push the drive unit into the correct position, i.e. so that the drawbar can be hung up when the door is closed and
the drive unit is in the CLOSED position.
- Tighten all the screws. For drive units whose door travel distance exceeds 3'500 mm, an additional suspension
must be mounted.
0552-999-04a_08.2001.p65
Attention:
Do not damage the drive head (10).
=
350 - 800
15 16 13
Attention:
The drive unit must be mounted parallel to the door
(maximum admissible deviation +/-20 mm).
Mount the drive unit as low as possible.
The drawbar may have a maximum deviation of 15°
from the horizontal position.
0552-999/04a
DBL-S
B
=
14 *
9-19
450
12
Fig. 7