Belkin F1UP0002 Mode D'emploi page 77

Web Management
Disable –
The internal DHCP server is disabled (recommended).
The Print Server has to get an IP address from a DHCP server
in the network or the user has to set the IP address manually.
Enable –
If DHCP is enabled, you have to assign a valid range
of IP addresses. Fill in the "Starting Address", "Range",
"Subnet Mask", "Gateway", and "DNS" fields; then the Print
Server will assign a unique IP to each DHCP client. However,
the Print Server itself will get an IP address from the external
DHCP server or use the configured static IP address, if the
Print Server is configured for either of these two options on
this page. Otherwise, the internal DHCP server will assign the
first IP address to itself if no external DHCP server is found
and the Print Server is not set up to use a static IP address.
77 77
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17