Certifications; Federal Communication Commission Interference Statement - Belkin F1UP0002 Mode D'emploi

Certifications

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
4. Consult the dealer or an experienced
radio technician for help.
FCC Caution
This equipment must be installed and operated in accordance with
provided instructions and a minimum 20cm (8 inches) spacing must
be provided between computer-mounted antenna and person's body
(excluding extremities of hands, wrist, and feet) during wireless
modes of operation.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party
responsible for compliance could void the authority to operate
equipment.
133 133
1
2
3
4
5
6
7
8
9
10
11
12 12
13 13
14 14
15 15
16 16
17 17