Parameter Setting Overall Diagram; Alarms - Cordivari Bollyterm Home Manuel D'utilisation

English
10.3.2

Parameter setting overall diagram

Parameter setting overall diagram (Follow the diagram below to display, change or set parameters)
STAND BY / RUN STAND BY / RUN
STAND BY / RUN
0. Heat Pump set point 0. Set point PDC
1. ΔT
1. ΔT
2. Set point res elet.
2. Heating element set point
3, 4, 5, 6, 7, 8, 9, ..., 13
3, 4, 5, 6, 7, 8, 9, ..., 13
A. N Temp. (T2 probe) A. Temp. IN (sonda T2)
B. Temp. OUT (sonda T3)
B. OUT Temp. (T3 probe)
C. Temp. Evaporatore
C. Evaporator Temp.
D. Temp. Gas ritorno
D. Gas return Temp.
E. Temp. Ambiente
E. Ambient Temp.
F. Step valv espansione
F. Expansion valve step

10.4 Alarms

When an error occurs or the protection mode is automatically set, the error message is shown on the control unit display and on the printed circuit by
means of a flashing indicator (red LED light).
CAUTION! If the operator notices that the described alarms are repeatedly triggered, switch the machine off and contact the
manufacturer or an authorised technical assistance centre, providing the details of the unit as displayed on its nameplate.
8.4.1 Alarm table
(see ALARM TABLE on the next pages)
Visualizza
Display value
valore
Visualizza
Display value
valore
Visualizza
Display value
valore
Visualizza
Display value
valore
Visualizza valore
Display value
Display value
Visualizza valore
Visualizza valore
Display value
Visualizza valore
Display value
Visualizza valore
Display value
Visualizza valore
Display value
- 44 -
Parametri modificabili Parameters editable
solo in modalità STAND BY
only in STAND-BY mode
Impostazione
Display value
Impostazione
Display value
Impostazione
Display value
Impostazione
Display value
valore
valore
valore
valore
Cod. 1910000001165 - nv01