User Interface - Cordivari Bollyterm Home Manuel D'utilisation

2
7
• setting parameters that can be modified by the user;
• checking the status of resources.
8.1 User interface
Display
1. Digital display
2. [UP] key
3. [DOWN] key
4. [ELEC. HEATING] 'ON/OFF' key
5. [ON/OFF] key
6. [TIMER] key
7. [CLOCK] key
The LCD digital display allows displaying the following data corresponding
to the icons listed below:
LCD SCREEN ICONS
L0 Time
L1 Key lock
L2 Parameter setting mode.
L3 Setpoint temperature (SET TEMP)
L4 Defrost activation (defrosting)
L5 Ventilation activation
L6 Heat Pump Heating mode active
L7 Hot water. Set temperature reached, DHW
available. (Heat pump in stand-by)
L8 Heating element activation
L9 DHW temperature (WATER OUT)
L10 Active timer / Timer 1 or 2 setting
L11 Timer ON - Timer OFF time setting
L12 Error message
L13 Connection NOT active
Cod. 1910000001165 - nv01
4 3
5 6
L8
L7
SET
L7
L7
E R R O R
L1
L12 L6 L10
[ON/OFF] KEY
Press the [ON/OFF] key at start-up to display all the icons on the
screen for 3 seconds, then the machine will switch to STAND-BY
mode.
Press the [ON/OFF] key in stand-by mode to activate the unit
and display the operating mode, the set setpoint (SET TEMP)
and the DHW temperature (WATER OUT), the timer status and
the time.
Press the [ON/OFF] key again to bring the unit back to "Stand-
by" mode.
Press the [ON/OFF] key in other modes to display the Home
page.
Keep the [ON/OFF] key pressed in OFF mode to start defrosting.
Simultaneously press the keys [ON/OFF] and [ELEC. HEATING]
to access parameter setting.
[UP] AND [DOWN] KEYS
These keys allow to:
- scroll through the parameter list (moving to the top [UP] or to
the bottom [DOWN] in the message chart) in STANDBY or ON
mode;
- change the parameter value when programming (value
increase [UP] or decrease [DOWN]);
- lock/unlock the keyboard by keeping both keys pressed for
more than 5 seconds
[HEATING ELEMENT] KEY
It allows to:
- Activate - deactivate the heating element according to the set
mode
- Activate only the heating element (if pressed in STAND-BY
mode)
- Activate - deactivate the ventilation function (if pressed for
more than 5 seconds)
- Access the parameter setting when pressed together with the
[ON/OFF] key.
- 37 -
L2 L3 L9
TEMP WATER
OUT
1
ON
2
OFF
L11 L0
English
1