Lighting; Replacing The Bulbs Fig.32; Glass Doors; Cleaning The Cabinet - Arneg Astana LX Manuel D'installation Et De Service

21. Lighti ng
The cabinet features LED lamps.
The light switch is located on the upper ceiling light profi le.

21. 1 Replacing the bulbs Fig.32

DANGER! Live parts. Electrocuti on.
REMOVE THE ELECTRIC POWER SUPPLY BEFORE ANY OPERATION!
Follow chapters 1-2-3-4-5
Protect the hands with work gloves
To replace the bulbs:
1. Disconnect the connector -A-
2. Remove the screws -B-
3. Replace the bulb with an identi cal one.
Aft er replacing it, reassemble all the parts by performing the operati ons in reverse order.
Only aft er having assembled all the parts, restore the electrical power supply.

22. Glass doors

Operati on Doors with aluminium frame
• to keep the door open, use the hook on the lower plate Fig.30
• to close, simply accompany the door in closing
Doors with PVC frame
• for angles greater than 90° the door locks to facilitate loading and cleaning
• to close, simply accompany the door in closing
i
It is the Customer's responsibility to inform consumers with suitable means of communica-
ti on about correct use of the doors.

23. Cleaning the cabinet

DANGER! Live parts. Electrocuti on.
REMOVE THE ELECTRIC POWER SUPPLY BEFORE ANY OPERATION!
DO NOT wet, spray water or clean directly the electrical parts of the cabinet (fans, inte-
rior lighti ng, electrical cables etc.)
DO NOT touch the cabinet with wet or damp hands or feet.
ATTENTION! Cold surfaces. Injuries, burning. Glass breakage.
Wait for the glass parts to reach room temperature.
DO NOT use hot water on the cold glass surfaces.
Protect the hands with work gloves
i
The products will deteriorate due to germs and bacteria.
Compliance with Hygiene Standards and the cold chain is indispensable to guarantee the
protecti on of consumer health
05060194 01 05-2022
operati ons
See chap.4.5
Astana LX - Mini Astana LX
English
57