Ultraflex UFLEX Manuel D'installation Et D'entretien page 12

NOTICE
2
In order to ensure a correct installation of the tabs,
use the bigger holes (indicated by
on the hinge plate.
NOTICE
The smaller holes (indicated by
are used for an installation replacing other systems.
3 After placing the hinge on the boat stern and after
checking all the proper measures, mark the hole
position. Make the preholes with a
tip with a depth of 32 mm (1.26") max.
4 Put sealant 3M 5200 into the preholes and fix the hinge to
the transom by using the supplied self-tapping screws (L L L L L ).
Once the hinge has been fixed, put some sealant 3M 5200 on
its perimeter.
NOTICE
All the supplied screws are made up of stainless steel. Do
not use any other kind of material.
5 For the fixing, put bracket (C C C C C ) on tab (B1
(F F F F F ) through the holes of the tab and bracket (C C C C C ), put washer
(D D D D D ) and tighten the self-locking nut (E E E E E ).
NOTICE
Make sure the bracket projecting part is directed to the
opposite side of the boat stern.
page 12
of 79 -
ELECTROMECHANICAL TRIM TABS
in the picture)
in the picture )
Ø
5,5 mm (0.217") drill
B1 B1 B1), insert screws B1
Installation and maintenance manual
Hinge for tab 9"x 9" and 12"x 9"
Hinge for tab 12"x 12"
Hinge for tab 12"x 18"
L
B1
E
D
C
B1
F