OEM PIZZAFORM PF Mode D'emploi page 40

2.5 MACHINE IDENTIFICATION - EC PLATE
This manual contains instructions for use and maintenance regarding the machine manufactured
by OEM – ALI S.p.A.
In the illustration is shown the positioning of the machine identification plate (see chapter 15.0
"Drawings and schemes enclosed") with the following information:
- [1] Name and address of manufacturer
- [2] EC Marking
- [3] Model definition
- [4] Serial number
D
CAUTION : The registration number [4] printed on the plate should be mentioned every
time you contact the manufacturer for information or to order spare parts.
Reproductions of the " EC MARKING" plate applied to the machine and relative "EC
CONFORMITY DECLARATION" can be found in the documents enclosed.
If the EC MARKING plate is accidentally damaged , removed from the machine or the
manufacturer seal which binds it to itself, is simply removed, the customer must absolutely
inform the company OEM – ALI S.p.A.
[1]
[2]
The plates described below are and must stay applied on the machine or on its components
(Machines Directive , Attachment 1, Item 1.7.3) In case of damage of one of these, the user should
order a copy using the procedure to order spare parts indicated in the proper chapter, informing
the paragraph number where the plate is described and the data of this document, repeated on
the heading of each page.
- a Plate on electric engine
- a Plate on control panel
- Rear Plates
2.0
4
ALI S.p.a.
V.le Lombardia, 33
Bozzolo (MN)
ITALY
i
TYPE
kW
V Hz
IP21
A
10 A
Nr
[4]
[3]