INSTALLATION MOTEUR/ MOTOR INSTALATION
3) Fixer le moteur brushless en place à l'aide des qua-
tre vis Chc 4x12mm.
C
Attach the brushless motor with the four socket head
C
screws 4x12mm.
C
C
4) Coller solidement à l'époxy lente les platines D et E
suivant la photo (gratter l'endroit du collage à l'inté-
E
D
rieur du fuselage pour une meilleure adhésion).
Glue with slow cure epoxy D and E trays as shown
(Sand scratch inside of the fuselage where glue ap-
plied).
E
5) Le contrôleur est fi xé sur sa platine avec du Vel-
cro®.
The ESC is attached on the tray with Velcro® tape.
6) Monter les pales d'hélice sur le cône puis visser le
porte-pale sur l'arbre moteur.
Attach prop blade to center hub with pin then screw in
to motor shaft.
7) Visser le cône en place.
Attach spinner with screw.
16