Table 3- 1
USA
EU
7. Within 10 seconds of power-up the main display will become active and an LCD display
3.2
Flowmeter connection using RS-232
RS-232 Connection
Figure 3-2
Flowmeter Communications and Programming via the RS-232 Interface (optional)
Note
Refer to the flowmeter manual for programming the meter using the RS-232 Interface or see
Quick Terminal Mode Setup procedure below.
To use the RS-232 Interface to program the flowmeter instead of using the main unit display
you must be familiar with the basics of the Windows 95/98/NT/2000/XP HyperTerminal
SITRANS FUH1010 Quick Start Guide
Operating Instructions, 1/2009, CQO:QSG009 Rev A
Color Codes
HOT
BK
BR
screen for use with the Magnetic Wand will appear as shown below.
①
LCD panel display showing initial screen with copyright notice.
Serial Port Program Menu Screen
3.2 Flowmeter connection using RS-232
NEU
GND
WH
GRN
BL
Y/GRN
Commissioning
17