Figure 2-1 Pipe Mounting 1010 And Mounting Bracket Locations - Siemens SITRANS F Serie Guide Rapide

Installation
2.2 Mounting the Flowmeter
Pipe Mounting
For installation on pipe use Pipe Mount Kit CQO:1012XMB-1 (optional - see catalog) See
figure below.
①
②
③
Figure 2-1
Note
Use conduit fittings or cable glands on all cables.
Note
Install weather tight seals at all unused holes using proper cable conduit and close additional
holes to IP65 standards.
14
Clamp
Mounting Bracket (Hardware not supplied for
wall mounting.)
Pipe
Pipe Mounting 1010 and Mounting Bracket Locations
④ U-Bolt Assembly for standard 2-inch
(2.38in/6.0452cm) pipe. (Hardware
supplied.)
⑤ Transducer Cable Entry Ports
⑥ Position Plastic Strip Under Clamp
SITRANS FUH1010 Quick Start Guide
Operating Instructions, 1/2009, CQO:QSG009 Rev A