Commissioning; Connecting Power - Siemens SITRANS F Serie Guide Rapide

Commissioning

3.1

Connecting Power

Turn off main power before installing AC connections to the flowmeter. Contact with
exposed wiring may lead to fire, electric shock, or serious personal injury.
1. Using a 1/16" Hex key, loosen the flowmeter Rear Housing Cover locking setscrew.
2. Unscrew the Rear Housing Cover and remove.
3. Locate power supply connector J8. Use the tables below and the part number of your unit
Power Supply Option Code
S
ZN
ZP
Note
Power Supply Module P/N label is located inside the front housing cover.
SITRANS FUH1010 Quick Start Guide
Operating Instructions, 1/2009, CQO:QSG009 Rev A
DANGER
to determine the correct input power source. (See ID label on right side of housing.)
① Flowmeter Number
② Transducer Type
③ Relay Type
④ Numeric Display
1010X-6SS2
1010X-6ZNS2
1010X-6ZPS2
⑤
⑥
⑦
Power Supply P/N
Power Supply Option
Language Option
Safety Rating Option
User Supplied Power
90-250 VAC Single Phase
9-36 VDC Negative Ground
9-36 VDC Positive Ground
3
15