Cleaning Of The Operating Element - Harvia sentiotec wave.com4 touch II Instructions De Montage Et Mode D'emploi

WC4-B-L: wave.com4 basic module power module
WC4-H-PCB: wave.com4 extension circuit board
WC4-H-H: wave.com4 humidity sensor
WC4-H-F2: wave.com4 bench sensor
WC4-IRX-P: wave.com4 Infra power element
WC4-SL-L: wave.com4 sound&light colour light
If WC4-B-L is combined with WC4-SL-L, the WC4-SL-EXT cable set is also required. See also
'Electrical connection – only for experts'.
wave.com4 sauna basic modules (WC4-B-L) with a production date prior to 12/2011 are not compatible
with the wave.com touch. The necessary software update can only be executed at the factory.
4

Cleaning of the operating element

Clean the operating element according to the degree of soiling.
Disconnect the entire control from the network.
Gently wipe the front of the operating element with a soft cloth (e.g. microfibre cloth) slightly wetted with neutral
soapy water.
Do not clean the reverse and the circuit board behind it yourself under any circumstances. This may
damage the device. Ask service personnel if necessary.
Due to the high temperature and the condensate in the sauna cabin, the wave.com4 touch operating
element is not suitable for installation in the sauna cabin.
WORLD OF WELLNESS
Instructions for installation and use P. 5/22
EN