Configuration Of The Power Elements For Connection To The Wave.com4 Touch; Wave.com4 Sauna Basic Module Wc4-B-L; Sound & Light Wc4-Sl-L; Wave.com4 Infra Wc4-Irx-P - Harvia sentiotec wave.com4 touch II Instructions De Montage Et Mode D'emploi

7 Configuration of the power elements for connection to the
wave.com4 touch

7.1 wave.com4 sauna basic module WC4-B-L

wave.com4 sauna basic modules (WC4-B-L) with a production date prior to 12/2011 are not compatible
with the wave.com4 touch. The necessary software update can only be executed at the factory.
The JPBM jumper is contained in the scope of supply of the wave.com4 touch. Install these into the 6-pin socket
connector as shown in the figure.
7.2 Sound & Light WC4-SL-L
The JPSL jumper set at the factory must remain in its position.
If several sound & lights (up to four devices are possible) are used, the JPSL jumper must remain in position for
all devices connected to the bus, contrary to the instructions in the operating and installation instructions.

7.3 wave.com4 Infra WC4-IRX-P

Install the jumpers enclosed with the wave.com4 touch at pin connector socket OPT3 on JP1. Where several
wave.com4 Infra power elements are used (up to four devices are possible) the configuration can be found in
the operating and installation instructions of the wave.com4 Infra.
WORLD OF WELLNESS
Instructions for installation and use – only for experts
Jumper basic module
Jumper SL
Jumper Infra
P. 9/22
EN