Setting Display Brightness; Menu Language; Feedback; Auto Main Window Time - Harvia sentiotec wave.com4 touch II Instructions De Montage Et Mode D'emploi

17.4 Setting display brightness

Navigate to the display brightness menu point. Pressing the OK button 3 will take you to the settings. You can
set the display brightness in levels (1-10) with the touch wheel 4. Confirm your selection with the OK button 3.

17.5 Menu language

Navigate to the 'Menu language' menu point. Pressing the OK button 3 will take you to the settings. You can se-
lect your language with the touch wheel 4. Confirm your selection with the OK button 3.

17.6 Feedback

Navigate to the Feedback menu point. Pressing the OK button 3 will activate/deactivate the feedback.

17.7 Auto main window time

Navigate to the 'Auto main window' menu point. Pressing the OK button will take you to the settings. You can set
the time in seconds (8-15) with the touch wheel 4. Confirm your selection with the OK button.
18

Setting pre-set time

The pre-set time can be set in 15-minute steps. The minimum pre-set time is one hour, the maximum pre-set time
24 hours.
Start the functions which should be switched on when the set pre-set time has elapsed in advance.
* For example, activate sauna operation (the temperature is displayed, the sauna heater heats up)
* Navigate to the 'Programmes' menu point and then to pre-set time.
* Confirming with the OK button 3 takes you to the sub-menu which allows you to set your desired value
with the touch wheel 4.
* Confirm your desired pre-set time with the OK button 3.
* Now activate the pre-switching time with a long press on button 1 .
* The wave.com4 touch operating element now goes into stand-by mode.
* The 'switch on in...' display appears and the timer operates.
The sauna heater (temperature value is taken from last executed configuration) starts after elapsing of the
visible time.
You can cancel this mode at any time by pressing button 1 (long press).
The pre-set time must be reset before every use- the settings are not stored.
The following components are not switched on when switch-on occurs via a pre-set time:
* Cabin light
* Colour light
* Ventilator
WORLD OF WELLNESS
Instructions for use for the user P. 20/22