Pan Limits - Dedicated Micros 2000 Manuel D'installation

8. Pan limits

The required angular pan movement of the unit can be set to any angle within the range of
5 to 350 Deg. A friction clutch design, as in tilt, eliminates the need for tools, The pan actuators are
situated around the mounting base. Simply rotate by hand to set the desired angle of movement.
B
Fig.11 Pan limits
Set-up procedure
1. The pan actuators are located in a pocket around the mounting base (D) as shown in fig.9
2. Rotate pan right (A) and pan left (B) actuators to give the desired angle of pan movement.
Note: It may be necessary to push actuators with a tool in certain restrictive positions.
3. The limit pin (C) actuates the internal microswitches to stop the supply to pan motor.
2000/2006 Installation Manual
A
C
D
Page. 7