Side Platform - Dedicated Micros 2000 Manuel D'installation

12. Side platform

Tilt Drive Boss
A
C
B
Fig.16 Side platform assembly
A. Unpack the side platform and Type 2000/2006 pan & tilt from its packaging
B. Locate side platform onto the tilt drive boss as shown
C. Attach side platform using 2 x platform spacers, 2 x M8 spring washers and 2 x M6 x 25
Socket head cap screws as supplied
D. Adjust limits as required (see tilt limit setup procedure in this document)
D
Fig.17 Side platform assembly
2000/2006 Installation Manual Page. 11