Dedicated Micros 2000 Manuel D'installation page 16

Addendum. Optional Preset Potentiometers
Preset potentiometer
Clutch adjuster
Fig.1 Preset Potentiometer positions
Preset option
(To provide a feedback signal to a controller monitoring the units position)
1. Drive the pan axis to the centre position of the required sweep angle & locate the pan preset
potentiometer as shown in fig.1.
2. Measure the resistance between pin 1 (0V return) &
preset connector.
3. Turn the clutch adjuster on the pan potentiometer (fig.1) to achieve a reading of 500 Ohms to
centre the Potentiometer.
4. Repeat the procedure for the tilt axis measuring the tilt potentiometer resistance between
pins 1 & 2 on the preset connector.
To replace a faulty potentiometer remove the fixing screws (2) (shown on fig.2) and remove the
assembly. Release the grub screw secuing the clutch assembly (4). Undo the nut (3) to remove the
potentimeter (1) from its mounting bracket.
Fig.2 Potentiometer exploded view
2000/2006 Installation Manual
1 2
Tilt Potentiometer
Pan Potentiometer
(pan position signal output) on the
3 4
Page. 14