Kenwood KAX910ME Instructions page 3

This appliance conforms to EC
G
directive 2004/108/EC on
Electromagnetic Compatibility and
EC regulation no. 1935/2004 of
27/10/2004 on materials intended
for contact with food.
This KAX910ME attachment
features the Twist Connection
System and is designed to fit
directly on the latest generation
Kenwood Chef models (identified
as KVC and KVL series).
This attachment can also fit Kmix
kitchen machines featuring a slow
speed attachment outlet (KMX
series).
To check that this attachment is
compatible with your kitchen
machine you will need to ensure
both components feature the Twist
Connection System
If your kitchen machine features
the Bar Connection System
you will also need an adaptor
before operation is possible. The
reference code for the adaptor is
KAT001ME. For more information
and how to order the adaptor visit
www.kenwoodworld.com/twist.
before using for the first
time
Wash the parts: see 'cleaning'.
G
key
hopper
feed tube
body
scroll
die*
securing nut
clamp ring of cutting assembly
cutting blade
spanner/pusher
cleaning tool
*Included in your pack is the
Maccheroni rigati die shown on
the illustration page. To purchase
any of the additional dies shown
on the back page of this booklet,
please call 0844 557 3653 or
contact the shop where you
purchased the attachment.
to assemble
1 Optional: for easier pasta making,
2 Fit the scroll inside the body.
3 Fit the die.
4 Fit the securing nut and hand
G
5 Lift off the slow speed outlet cover
6 With the attachment in position
7 Fit the hopper.
.
1 With the handle of the cutting
2 Hold the edge of the cutting
3
warm the body, die and ring nut in
hot water, then dry.
tighten. (Don't use the
spanner/pusher as this is to assist
with removal only).
Make sure the securing nut is
almost flush against the body of
the attachment.
by pressing the top and lifting off
.
shown, locate to the slow speed
outlet and rotate to lock in place
.
Optional: The cutting assembly
can be fitted to the assembled
pasta maker to assist with cutting
the pasta into the desired lengths.
blade uppermost, unscrew the
clamp ring slightly. Place over the
securing nut and twist if necessary
until fully home on the attachment.
The die should fit flush with the
front of the cutting assembly.
assembly and at the same time
tighten the clamp ring by turning
away from you
Note – Whenever you fit or
remove the cutting assembly,
always hold the edge of the
assembly in one hand and twist
the clamp ring with the other.
.