Inspecting The Bagger Attachment; Cleaning The Bagger And Bags; Inspecting The Blower Belt; Replacing The Blower Belt - Toro 78463 Manuel De L'opérateur

Inspecting the Bagger
Attachment
Service Interval: After the first 10 hours
Before storage
Inspect the bagger attachment after the first 10 hours
of operation, and monthly thereafter.
1. Check the chute, discharge tube, and the bagger
top. Replace these parts if they are cracked or
broken.
2. Tighten all nuts, bolts, and screws.
3. Inspect all fasteners and latches; replace any
missing or damaged.
4. Inspect the grass bags for deterioration.
WARNING
You or bystanders could be severely
injured by flying debris or thrown objects
that may pass through torn, worn, or
deteriorated grass bags.
• Check the grass bags for holes, rips,
wear, and other deterioration.
• If the bag has deteriorated, install
new grass bags supplied by
the manufacturer of this bagger
attachment.
Cleaning the Bagger and
Bags
Service Interval: Before each use or daily
The bagger needs to be cleaned daily.
1. Wash the inside and outside of the bagger
hood, bags, tube, and the underside of the
mower deck. Use a mild automotive detergent
to remove dirt.
2. Ensure that you remove matted grass from all
parts.
3. After washing all the parts, let them dry
thoroughly.
Note:
With all parts installed, start and run the
machine for approximately 1 minute to assist in drying.

Inspecting the Blower Belt

Service Interval: After the first 8 hours
Every 25 hours
Check belts for cracks, frayed edges, burn marks,
or any other damage. Replace any belts that are
damaged.

Replacing the Blower Belt

1. Disengage the PTO, move the motion-control
levers to the N
engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Loosen or remove belt guide
4. Pull back on the spring-loaded idler pulley to
relieve the belt tension
1. Spring-loaded idler pulley
2. Mower-deck pulley
3. Belt
4. Spring
5. Remove the existing blower belt.
6. Install the new belt around the blower pulley
(Figure 40).
7. Tighten or install the belt guide
8. Install the spring as shown in
29
- position, and
EUTRAL LOCK
(Figure 40).
(Figure 40).
Figure 40
5. Belt guide
6. Idler pulley
7. Blower pulley
(Figure
Figure 41.
g189890
40).