Toro 78463 Manuel De L'opérateur page 25

Note:
There is a latch on the top and bottom
of the blower housing.
Figure 35
1. Blower assembly
2. Lower tube
7. Ensure that the machine deck is in the lowest
height-of-cut position.
8. Verify that the dimple from
place.
9. Using the 3 holes or indentations in the upper
tube as a template, and drill 3 holes (7/32 inch
g003449
3. Latch (twin bagger shown)
Figure 33 is still in
diameter) where the upper and lower tubes join
together (Figure
1. Bagger hood
2. Upper tube
3. Lower tube
10. Remove the lower tube from the blower housing.
23
36).
Figure 36
4. Blower assembly
5. Drill holes (7/32 inch)
g037981