Replacing The Grass Deflector; Important; Storage - Toro 78463 Manuel De L'opérateur

Replacing the Grass
Deflector
WARNING
An uncovered discharge opening could allow
the machine to throw objects toward you or
bystanders, resulting in serious injury. Also,
contact with the blade could occur.
• Never operate the machine without a
grass deflector, a mulch plate, or a bagger
system installed.
• Ensure that the grass deflector is in the
down position.
1. Place one end of the spring behind the deck
edge and the other end on the grass deflector
(Figure 43).
Figure 43
1. Bolt
2. Spacer
3. Locknut
4. Spring
2. Use the bolt and nut to secure the grass deflector
assembly to the mower deck
3. Place the J-hook end of the spring around the
grass deflector (Figure

Important:

The grass deflector must be able to
lower down into position. Lift the deflector up to
test that it lowers into the full-down position.
g015594
5. Spring installed
6. Grass deflector
7. End of spring
(Figure 43).
43).

Storage

1. Empty the bagger attachment; refer to
the Grass Bags (page
2. Inspect the bagger attachment for damage.
3. Ensure that the bags are empty and thoroughly
dry.
4. Inspect the belt for wear or cracks; refer to
Inspecting the Blower Belt (page
5. Store the machine in a clean, dry place, out of
direct sunlight. If you must store the machine
outside, cover it with a weatherproof cover. This
protects the plastic parts and extends the life of
the machine.
31
Emptying
25).
29).