Toro 78463 Manuel De L'opérateur page 13

2. Remove the 2 torx-head bolts and 2 nuts from
the left, rear guard
Note:
Perform the step above on 1 side of the
machine, then the other.
Figure 8
1. Left, rear guard
2. Nut
3. Loosely secure the left, upper bracket to the left,
rear guard and upper support using 2 hex-head
bolts (5/16 x 3-1/4 inches), 2 plain washers, 2
flange nuts (5/16 inch), 1 flange-head bolt (3/8 x
1-1/4 inches), and 1 locknut (3/8 inch) as shown
in Figure 9.
Note:
Perform the step above on 1 side of the
machine, then the other.
Figure 9
1. Left, rear guard
2. Flange nut (5/16 inch)
3. Locknut (3/8 inch)
4. Upper support
(Figure 8).
3. Torx-head bolt
5. Flange-head bolt (3/8 x
1-1/4 inches)
6. Left, upper bracket
7. Plain washer
8. Hex-head bolt (5/16 x
3-1/4 inches)
4. Loosely secure the lower support to the engine
plate using 2 carriage bolts (5/16 x 2-1/4 inches),
1 backer plate, and 2 flange nuts (5/16 inch) as
shown in
Note:
Perform the step above on 1 side of the
machine, then the other.
g341515
1. Backer plate
2. Carriage bolt (5/16 x 2-1/4
inches)
5. Tight all the fasteners.
g341516
11
Figure 10.
Figure 10
3. Lower support
4. Flange nut (5/16 inch)
g341517