Positioning Of The Inner Slide; Replacing Of The Cable Gland Plate With Stainless Steel Plate Supplied - Videotec HGV Manuel D'instructions

Fasten the aluminium plate (01) on the slide by
means of the 2 M4 screws and relative washers (02).
Fig. 07
Then fasten the two small plates
with the M4 screw (01).
Fig. 08
6.2.1.2 Positioning of the H20
spacer in the inner slide
Perform the same operations shown in Fig. 05, page 5.
It is possible to fasten the H20 spacer (02) to the
lens, interposing a plastic spacer (01) of the required
thickness, by means of washer and screw (03).
Fig. 09
Position the lens with the spacer (01) in the inner
slide (02) and fasten the spacer by means of the
washers and screws (03) provided as standard.
6
01
02
Fig. 10
Now proceed with the operations shown
in Fig. 07, page 6 and Fig. 08, page 6.

6.2.2 Positioning of the inner slide

Shift the inner slide with lens and camera already
fastened into the wanted position and secure it by
means of the four washers and screws provided.
01
Fig. 11
6.2.3 Replacing of the cable gland plate
with stainless steel plate supplied
h
01
02
03
Drill the plate supplied as required.
Fig. 12
In order to maintain the housing's IP66
degree of protection it is necessary for the
connector or cable gland inserted in the
plate to have the same degree of protection
120 mm
Useful drilling area.
01
02
03