Other Settings Installer; Factory Setting - Brink Renovent Excellent 180 Consignes D'installation

Putting into operation
factory at 50, 75, 100 and 150 m
energy consumption of the Renovent Excellent depend on the
stance.
Important:
Setting : is 0 or 50 m 3 /h (not for 3-way switch),
Setting 1 : must always be lower than setting 2,
Setting 2 : must always be lower than setting 3,

7.3 Other settings installer

Various other settings of the Renovent Excellent can also be

7.4 Factory setting

ting in one go.
Renovent Excellent was supplied from the factory; all message
codes / fault codes will be erased from the service menu as
well.
3
/h. The performance and the
3
/h.
Renovent Excellent 180
-
-
Chapter 7
press > 10 sec.
simultaneously
3 sec. displayed
operating mode
21