Operating Mode; Status System Fan - Brink Renovent Excellent 180 Consignes D'installation

Display layout

6.2 Operating mode

In operating mode, the display may simultaneously show 4 dif-
ferent situations/values.
1 = Status fan mode, shows coupled appliances (see
§ 6.2.1)
(see § 6.2.2)
3 = Message text
switch contact etc. (see § 6.2.3)
4 = Fault symbol (see § 8.1 and § 8.2)

6.2.1 Status system fan

This part of the display shows a fan symbol together with
a number.
When the supply and exhaust fans are running, the fan
symbol is displayed. When the fans are stopped, the fan
symbol is not visible.
The number behind the fan symbol indicates the fan mode.
Refer to the table below for an explanation of the numbers.
Status fan
Description
mode on display
The supply and exhaust fans are running at 50 m
This situation depends on the setting of step number 1 (see chapter 13)
The supply and exhaust fans are running under mode 1 of the multiple switch.
1
The supply and exhaust fans are running under mode 2 of the multiple switch.
2
The supply and exhaust fans are running under mode 3 of the multiple switch.
3
This Renovent Excellent is linked through eBus.
The supply and exhaust fans of the Renovent Excellent are running under the switched mode of the ven-
tilation mode "master" Renovent; in addition, (only for cascade connection) the display shows the "slave"
number of the relevant Renovent.
1) With application of a 3-way switch, mode
fan.
fans differ, for instance when using an external switch con-
When the appliance is switched off through software, the
text "OFF" appears here (see §7.1).
3 /h or they are stopped.
cannot be used.
Renovent Excellent 180
Chapter 6
1)
15