Axis Q60 Série Guide D'installation page 28

6
Ethernet wire (orange)
7
Digital I/O wire (yellow)
8
Ground wire (black)
9
Power wire (red)
10 Power connector (DC output)
11 Ethernet connector (internal)
12 Ethernet connector (internal)
13 I/O connector (internal)
14 Ground clip
15 Braided shield coil
16 Outer foil shield
17 Ethernet wire shield (2x)
18 Clamp
11. Make sure the clamp is in place, insert the braided shield coil into the ground clip and
tighten the screws.
NOTICE
NOTICE NOTICE
• The shields and the clamp surfaces shall be in full contact with each other so that the
multi-connector cable is grounded.
• Make sure all surfaces and contacts are clean and free from scrap shield material.
12. Connect the network cables to the external network connectors (RJ45, SFP) as required.
28
AXIS Q60 Series