Axis Q60 Série Guide D'installation page 24

NOTICE
NOTICE NOTICE
To prevent corruption of recordings, the SD card should be unmounted before it is ejected.
To unmount, go to Setup > System Options > Storage > SD Card and click Unmount.
Install the Power Supply and the Media Converter Switch
The supplied media converter switch enables the multi-connector cable to send power from the
power supply (sold separately) and to send and receive data to and from external alarm devices
and the network.
NOTICE NOTICE NOTICE
• Make sure the connections to the mains supply and conduits have been installed by a
trained professional, according to the manufacturer's instructions and in compliance
with local regulations.
• The power supply (sold separately) and the media converter switch shall be installed in an
environment protected against dust and water, for example indoors or in an appropriate
cabinet.
• The product shall be connected using a shielded network cable (STP). All cables connecting
the product to the switch shall be shielded (STP) and intended for their specific use. Make
sure that the switch is properly grounded. For information about regulatory requirements,
see Regulatory Information, on page 2.
Important
Axis can only guarantee full functionality with the supplied media converter switch. No
other devices are supported.
1. Make sure the mains supply is switched off.
2. Mount the power supply and the media converter switch on the wall or, if applicable,
attach them to a DIN rail in the cabinet. If drilling is required, make sure to use drill bits,
screws, and plugs that are appropriate for the material.
3. Loosen the screws and remove the cover from the media converter switch.
24
AXIS Q60 Series