Axis Q60 Série Guide D'installation page 31

AXIS Q60 Series
2. Route the multi-connector cable through the holes in the mounting bracket.
3. Secure the camera using the supplied safety wire.
Mounting example (wall bracket sold separately)
1
Slot for unit holders (3x)
2
Screw T30 (2x)
3
Safety wire
4. Remove the protection cap covering the multi-connector on the camera.
5. Connect the multi-connector cable to the connector on the camera. Use the alignment
indicators to find the correct position.
NOTICE NOTICE NOTICE
Be careful not do damage the multi-connector cable when connecting it.
31
1
2
3