Status Leds; Initial Operation; Remote Control; Power Supply - DURAVIT SensoWash Slim Notice D'utilisation

If the remote control is not available or the batteries are empty,
then basic functions can also be switched on or off from the side
control buttons.
1
EN
2

4.2 Status LEDs

Red illuminated:
Orange illuminated: SensoWash
Green illuminated:
Green flashing:
Red flashing:

5. Initial operation

Remote control

> Press the lock of the "Battery Compartment"
> Remove the foil safety tag in the battery compartment.
> Close the "Battery Compartment"

Power supply

> Connect the main power supply.
SensoWash
it is connected to the power supply. During this time the "Status
LED"
B
work, all other operations will not work.
14
3
SensoWash
all functions cannot be used.
all functions can be used.
SensoWash
all functions can be used.
SensoWash
only „Power"
Malfunction. Disconnect main power supply
and proceed with chapter 9.
will start "Initialization" for about 15 seconds when
®
flashes green and only "Power"
is in the „Standby mode",
®
is in the „Energy saving mode",
®
is in the „On mode",
®
is in the „Initialization" process,
®
on the seat unit can work.
A
8
.
8
on the seat unit can
A
to open it.