Status Leds; Initial Operation; Remote Control; Power Supply - DURAVIT SensoWash Slim 611000 Notice D'utilisation

4.2 Status LEDs

Red illuminated: SensoWash
Orange illumina-
ted:
Green illumina-
EN
ted:
Green flashing:
Red flashing:

5. Initial operation

Remote control

> Press the lock of the "Battery Compartment"
> Remove the foil safety tag in the battery compartment.
> Close the "Battery Compartment"

Power supply

> Connect the main power supply.
SensoWash
it is connected to the power supply. During this time, the
"Status LED"
unit can work, all other operations will not work.
Switch SensoWash
Requirement: SensoWash
LED" is red illuminated.
B
> Press "Power"
SensoWash
The "Status LED"
All functions can be used.
12
tions cannot be used.
SensoWash
functions can be used.
SensoWash
can be used.
SensoWash
only "Power"
Malfunction. Disconnect main power supply
and proceed with chapter 9.
will start "Initialization" for about 15 seconds when
®
flashes green and only "Power"
B
on
®
is in the "Standby mode", the "Status
®
on the seat unit.
A
is now switched on.
®
is green illuminated.
B
is in the "Standby mode", all func-
®
is in the "Energy saving mode", all
®
is in the "On mode", all functions
®
is in the "Initialization" process,
®
on the seat unit can work.
A
.
9
to open it.
9
on the seat
A