DURAVIT SensoWash Slim Notice D'utilisation page 7

• Do NOT use the product if it is not working properly.
Disconnect from the power supply immediately. Close the stop
valve to interrupt the water supply. Contact help@duravit.com.
Avoid malfunctions and damage to the product as a result of
improper use.
CAUTION
• Supply the device with cold drinking water from the main water
system.
• The new hose-sets supplied with the appliance are to be used
and old hose-sets should not be reused.
• The product itself does not have electrical leakage protection
function, it must be installed in circuit where there is leakage
protection device installed.
• Means for disconnection must be incorporated in the fixed
wiring in accordance with the wiring rules and having a
contact separation in all poles that provide full disconnection
under overvoltage category III conditions.
• Wire specification of cable is cross section
1 – 2.5 mm (17 – 14 AWG).
2
• Confirm that the grounding wire is 10 mm (⅜") longer than the
L and N wire.
• Confirm that the electric connection box must be fixed on wall
before installation.
• Do NOT sit, stand or lean on the lid.
• Do NOT connect any waste water, grey water, industrial water,
sea water or other untreated or semi-treated water.
• Do NOT detach seat and lid for any purpose
• Do NOT damage the surface of seat.
• If the surface of the seat is damage, contact help@duravit.com.
• DO NOT open and close seat and lid with excessive force.
• If the SensoWash
location, condensation may form. Leave the unit switched off for
a few hours.
• Do NOT install the SensoWash
ger of frost. The room temperature must not be less than 4°C.
Health damage and potential product damage!
is moved from a cold location to a warm
®
®
in rooms where there is a dan-
EN
7