DURAVIT SensoWash Slim Notice D'utilisation page 27

Problem
The "Status
LED" on the
unit flashes
red three times
each 3 seconds.
The "Status
LED" on the
unit flashes red
four times each
3 seconds.
A continuous
confirmation
tone is audible.
General function
SensoWash is
®
not working.
A water leak
exists.
Potential cause
Malfunction.
Malfunction.
Malfunction.
SensoWash is
®
not switched on.
("Status LED" is not
illuminated)
SensoWash is in
®
Standby mode.
("Status LED" is red
illuminated)
Malfunction.
Solution
> Contact
help@duravit.com.
> Turn off "Water
temperature" .
> Activate any shower
function.
> Cut off the power
supply.
> After 30 sec.
connect it again.
> Switch on the main
power supply.
> Switch to "On mode". 6.1
> Close the main
valve for the water
supply.
> Disconnect the
power supply.
> Call the installer.
Ch.
6.2
EN
27