Maximum Operating Time Exceeded; Oven Light - Thermador Masterpiece Serie Mode D'emploi

Oven light is not working properly.
Oven light does not turn off.
Cannot remove lens cover on light.
Oven is not self-cleaning properly.
Clock and timer are not working properly.
"E" and a number appears in display and control
beeps.
With a new oven there is a strong odor when oven is
turned on.
Control does not react when a key is touched.
Fan is running during modes that do not use convec-
tion.
Warm air or steam escapes from oven vent.
Cooling fan runs even when the oven is turned off.
Oven door closes faster/slower than normal.
The appliance cannot be switched on or is on and
cannot be operated; the
display.
The appliance does not heat up;
display.

Maximum Operating Time Exceeded

Your appliance automatically ends the operation if no
duration has been set and the setting has not been
changed for 24 hours.
The actual cooking time until the operation is stopped
automatically varies according to the selected settings.
A message appears on the display on the appliance to
say that the operation is being ended automatically.
Afterwards, the operation is stopped.
To use the appliance again, first switch it off. To switch
the appliance back on set the required operation.
36
symbol is shown on the
‚
is shown on the
6
Replace or reinsert the light bulb if loose or burned out.
Touching the bulb with fingers may cause the bulb to burn
out.
Check for obstruction in oven door. Check to see if hinge is
bent.
There may be soil build-up around the lens cover. Wipe lens
cover area with a clean dry towel prior to attempting to
remove the lens cover.
Allow the oven to cool before running self-clean. Always wipe
out loose soils or heavy spillovers before running self-clean.
If oven is badly soiled, set oven for the maximum self-clean
time.
Make sure there is electrical power to oven.
This is a fault code. Follow the instructions in the display. If
the code remains or there are no instructions in the display,
press INFO to display more information (if applicable) and to
turn off the beep. If the code is still displayed, write down the
fault code number, turn off the oven, and call Service.
This is normal with a new oven and will disappear after a few
uses. Operating the self-clean cycle also "burns-off" the
smell more quickly.
Be sure that pad is clean. Touch the center of the touchpad.
Use the flat part of your finger.
On some models, the convection fan runs while the oven is
preheating for the bake mode. This is normal.
It is normal to see or feel steam or warm air escaping from
the oven vent. Do not block the vent.
This is normal. The cooling fan will continue to run, even after
the oven has been turned off, until the oven has cooled suffi-
ciently.
The soft-close door hinges contain a damping fluid that is
affected by temperature. If the oven is in a cold environment,
the door will close slower than it will in a warmer environ-
ment. A warmer than normal environment, such as when
cooking, may cause the door to close slightly faster.
The panel lock is activated. Press and hold the LOCK touch
button (or TIMERS, if LOCK is not present) until the
bol goes away.
Demo mode is activated in the basic settings. Turn demo
mode to OFF in the settings menu.

Oven Light

To replace the halogen bulb on the oven sidewall:
Tools required
sym-
‚
Narrow flat blade screw-
driver (blade tip width 1/
5" (5 mm) or less to fit in
slot).
Flashlight (to see socket
holes to plug in bulb
prongs).
G-9 Halogen bulb