Avoid These Cleaners; Service; Troubleshooting Chart - Thermador Masterpiece Serie Mode D'emploi

Setting
The "Self Clean " function can only be started once the
˜
oven cavity is cold (room temperature) and the appliance
door is closed.
For your safety the appliance door is locked during this
operation.
Depending on the degree of soiling you can select three
different intensity levels for the Self Clean cycle:
Intensity level Duration (excluding cool off)
high 3 hours
medium 2 ½ hours
low 2 hours
Remove the accessories from the oven cavity.
1.
Touch the ON l OFF touch button.
2.
Touch the MENU touch button.
3.
Swipe to the left or right to select "Self Clean
4.
Select a cleaning intensity.
5.
Touch "Continue".
6.
Confirm that you have removed heavy soil and
7.
accessories from the oven cavity.

Service

Faults often have simple explanations. Before calling
Customer Service, please refer to the table below and
attempt to correct the fault yourself.
WARNING
9
RISK OF ELECTRIC SHOCK
Improper repairs are dangerous. Only an authorized
servicer may perform repairs and may replace
damaged plug and connections. Remove the power
plug or turn off the circuit breaker or fuse in the fuse
box if the appliance is damaged or not working. Call
Customer Service.

Troubleshooting Chart

Oven Problem
Oven door is locked and will not open, even after cool-
ing.
Oven is not heating.
After switching on an operating mode, a message is
shown on the display that indicates that the tempera-
ture is too high.
Oven temperature is too hot or too cold.
Touch the START l STOP touch button.
8.
The door lock is activated automatically. The Self
Clean program is started.
Note: After the completion of a Self Clean cycle, the
oven will not allow you to start another Self Clean cycle
for 24 hours. For a double oven, if one cavity runs Self
Clean, neither cavity may operate a Self Clean cycle for
24 hours.
When Self Clean is Completed
When the Self Clean program has run through, a signal
sounds and the appliance ends the operation
automatically.
The appliance will remain locked while cooling off. Once
the oven cavity has cooled off, the lock will be
deactivated automatically.
Wipe out the remaining ash from the oven cavity with a
damp cloth.
".
˜

Avoid These Cleaners

Do not use commercial oven cleaners such as Easy
Off®. They may damage the oven finish or parts.
Never use scouring pads or abrasive cleaners.
WARNING
9
RISK OF ELECTRIC SHOCK
Work on the appliance electronics must be
▯
performed by an authorized servicer.
Always disconnect the appliance from the power
▯
supply when work is carried out on the
electronics. Switch off the circuit breaker or
remove the fuse from your household fuse box.
Possible Causes and Suggested Solutions
Turn the oven off at the circuit breaker and wait five minutes.
Turn breaker back on. The oven should reset itself and will
be operable.
Check circuit breaker or fuse box to your house. Make sure
there is proper electrical power to the oven. Be sure oven
temperature has been selected.
The appliance has not cooled sufficiently. Allow the appli-
ance to cool and switch the operating mode on again.
The oven thermostat needs adjustment. See "Oven Tempera-
ture Offset" under "Adjust Basic Settings".
35