Using On Carpet; After Steamer Use / Using Cooling Base - Hoover Eenhanced Clean Manuel Du Propriétaire

usinG on CarPet

WARNING
!
Do not clean over floor electrical outlets.
Do not use unit or press the trigger with no
water in the tank.
IMPORTANT
When using on carpets, always ensure the
Microfiber pad is properly attached to the floor
head.
„
Attach Multi-Surface Microfiber Pad.
and press the power button on the steamer.
„
The unit will take roughly 30 seconds to be
ready to produce steam.
ready to be produced, the green "steam
ready" indicator will illuminate.
„
Place the steamer into the carpet glider (2.17).
„
To recline the steamer place foot on floor
head and tilt handle (2.18).
„
To produce steam squeeze the trigger
„
Move the Steam Mop slowly backwards and
forwards across the floor (2.20) paying
particular attention to high traffic areas.

aFter steaMer use / usinG CoolinG base

„
After using Steam Mop and to avoid damage
to your floors, unplug and place Steam Mop
in cooling base (2.21) until product cools.
Once steamer is cooled, remove steam pad
and follow "how to clean" instructions in
Microfiber pad section on page 11 to avoid
mold and mildew.
2.17
!
2.19
Plug in
Once steam is
(2.19).
2.21
10
2.18
2.20