Using Your Cleaner; Dry Vacuuming; Wet Vacuuming - Hoover MULTI FUNCTION PRO Mode D'emploi

ASSEMBLING YOUR CLEANER
Remove all components from the packaging.
1. Remove the castors from inside the tank, by releasing the securing latches to access the
tank. Turn the tank upside down and attach the castors into the holes.
2. Connect the hose by inserting the hose connector to the product with the arrow towards
the top, then rotate clockwise until locked [5].

USING YOUR CLEANER

1. Ensure the product is correctly assembled together with the securing latches.
2. Assemble the accessories you require for the specific task.
3. The product is operated by switching the on/off switch (C).
4. To adjust the performance the suction regulator can be adjusted: [2]
Suction regulator open = reduced performance
Suction regulator closed = maximum performance
5. Select the correct combi floor nozzle insert for the surface you are cleaning [3]:
5.1 Bristles for hard floor (Q2)
5.2 Rubber for liquid (Q3)
5.3 Plastic for carpet (Q1)
6. Parking and Storage - The flexible hose and tubes can be parked for temporary storage
while in use [1] or in storage position when not in use [3]: Remove nozzle, tubes and hose.
Wrap the flexible hose around the product and park the hose handle on the product [4].
Assemble the nozzle into the parking slot on tank. Assemble tubes into the remaining
parking slots.

dry Vacuuming

notE: After wet vacuuming, the appliance must be absolutely dry.
1. Ensure the pre-motor filter is fitted correctly. never dry vacuum without filters or with
damaged filters.
2. Ensure the dust bag is fitted correctly [9].
3. when the product loses suction, stop vacuuming and check the bag. Replace it if necessary.
A dust bag is essential when vacuuming fine dust (i.e. ashes, cement, etc). However it
is recommended for normal use as it not only improves the retention of dust, but also
protects both the motor and pre-motor filter.

Wet Vacuuming

notE: never use a dust bag or pre-motor filter when vacuuming liquids.
Multifunction_Pro__3-8_union.indd 5
5
GB
23-04-2010 14:10:27