Turning Cleaner On And Adjusting Power Level; Cord Release; Stair Cleaning; Floor Selection - Hoover Envy Hush Guide D'utilisation

turninG cleaner on and
adjustinG power leVel
2.2 After assembling
cleaner, plug cord into
electrical outlet. Turn
cleaner ON by stepping
on the ON/OFF pedal
(A).
The suction control
can be increased or
decreased by sliding
the control (B) towards
MIN or MAX.
To turn cleaner OFF,
step on the pedal.

stair cleaninG

2.3 Clean stairs by
placing cleaner on end.
Clean stairs from bottom
to top.
WARNING
!
Use extra care when cleaning on stairs. To avoid
personal injury or damage, and to prevent the
cleaner from falling, always place cleaner at
bottom of stairs or on floor. Do not place cleaner
on stairs or furniture, as it may result in injury or
damage.
2.2
b
A
2.3
!

cord release

Grasp the end of the plug and pull to release cord
from cord reel until red tape is reached.
IMPORTANT
When pulling on the cord, yellow tape will identify
when the cord is almost fully extended. When red
tape is visible on the cord, the cord has reached
its allowable extended length. Do not pull the
cord out any further.
floor
selection
2.4 Push brushroll
button (A) to
brushroll On and Off.
brushroll on: Vacuums
carpets.
brushroll off:
Vacuums hard floors.
7 Actual model may vary from images shown.
2.4
turn
A