Wireless Lan Setting; Adjusting The Antenna; Using Optical Cable; Using Rca Cable - TechniSat DIGITRADIO 110 IRr Mode D'emploi

2.3 Wireless LAN Setting

> A broadband Internet connection.
> A wireless access point (Wi-Fi) connected to your broadband Internet, preferably via a router.
> If your wireless network is configured to use Wired Equivalent Privacy (WEP) or Wi-Fi Protected Access
(WPA) data encryption then you need to know the WEP or WPA code so you can get the Internet Radio
to communicate with the network.
> If your wireless network is configured for trusted stations you will need to enter the Radio's MAC address
into your wireless access point. To find the Radio's MAC address use menu items as follows: Main menu
> System settings > Network > View settings > MAC address.
Before you continue, make sure that your wireless access point is powered up and connected to your
broadband Internet. To get this part of the system working, read the instruction supplied with the wireless
access point is highly recommended.

2.4 Adjusting the Antenna

Unwind the DAB/FM antenna and screw it to Antenna socket on the back of the unit to ensure you receive
the best reception possible in both DAB and FM radio modes. It may be necessary to adjust the position of the
radio and /or antenna to achieve the best signal.

2.5 Using Optical Cable

Connect a fiber-optical digital cable to Optical Out socket on the back of the unit will allow your radio
transmitting digital signal to audio equipment.

2.6 Using RCA Cable

Connect the 3.5 mm plug at the end of your RCA cable to the Audio Out socket on the back of this unit. Then
insert the Red and Black plugs at the other end of the RCA cable to your audio device.
10