TechniSat DIGITRADIO 110 IRr Mode D'emploi page 41

5. Multi-room capable devices can be connected to play synchronously if they are added to a group.
6. Edit group through App, taping 'Edit' at the right-top corner on device list.
a. Tap '+ Create Group' at the bottom on device list to create a new group and then enter a group name
or select one usual name from the list, and then select 'Create'.
b. As many new groups can be created as needed. The new empty groups are shown at the top of the
list. Hold down the three horizontal line and then drag your radio into group.
Note: some modes are not supported when grouping your radio. If your radio is in mode DAB, FM or
Bluetooth you cannot move it into the selected group.
c. If your radio is a client in the group, the radio display will show "Waiting for synchronisation" and then
the radio will play the same program as master device playing.
d. Tap 'Close' at top-right corner on editing screen to leave editing. (Refer to Figure 1.)
e. The devices in the group will be listed below group name. Tap on group name to select the group.
f. Group will synchronously play the program which the master device is playing. You can drag the
volume control bar to change the master volume for all grouped devices. You also can tap on the volume
control and then change volume for each device respectively. (Refer to Figures 2 and 3.)
Note: when select playing mode, the standalone modes (DAB, FM or Bluetooth) are incompatible for
grouped devices, if you select these modes, the master device will be removed from group.
EN
FR
IT
NL
PL
CZ
SK
41