Positioning A Dehumidifier; Parts Identification - Dri-Eaz Evolution LGR F292-A Guide D'utilisation

POSITIONING A DEHUMIDIFIER

For best results, operate your dehumidifiers in an
enclosed area, as this creates a drying chamber. Close
all doors and windows that open to the outside to
maximize the unit's water removal efficiency. Also, keep
traffic though the drying chamber to a minimum. Place
your Evolution dehumidifier against a wall, away from
obstructions, and keep it away from anything that could
block airflow into and out of the unit.
IMPORTANT: Before moving the unit, make sure there's
no water in the pump. See how to use the PURGE
function under "How to Use the Control Panel" on
page 3.
Managing temperature rise
Controlling temperature in the drying environment is
critical. The most accurate way to monitor temperature is

PARTS IDENTIFICATION

FIG. A: BACK
07-01480C 2010-01
Handle (in stored
position).
Hose storage tabs.
Rotate upper tab to
release hose.
Location of pump
and catch basin.
FIG. C: HOSE STORAGE
with a thermo-hygrometer; however, you can use an
indoor/outdoor thermometer to gauge temperature. For
improved accuracy, take temperature readings in the
center of the room, away from the airflow of the
dehumidifier.
Dri-Eaz dehumidifiers warm the air as they remove
moisture. Optimal drying temperatures range from 68–
85°F (20–29°C). This may require the use of the
building's HVAC (heating or air conditioning) system. If
heating and cooling is not available at the site, call a Dri-
Eaz at 800-932-3030, and a Technical Specialist help
you find an appropriate solution.
For more information about creating an optimum drying
environment, contact Dri-Eaz at 800-932-3030.
FIG. B: SECURING HANDLE
Rotate hose
storage tab
180 degrees to
the right to
release drain
hose.
2
1. Rotate locking lever to
right to release handle.
2. Raise handle to upright
position and secure in
place with locking lever.
3. Reverse procedure to
secure handle for shipping
and storage.
Dri-Eaz Products, Inc.